LLeeiiccaa DDIISSTTOO™™ PPlluussDDrraaww™™ UUsseerr MMaannuuaall vv11..00 AAPPEEXX SSOOFFTTWWAARREE
7Tap on any tab shown in Image 12 to display the corresponding view. Tab A: Drawing View This view will display the sketch based on
8 Tab B: Comments View This view will allow information about the sketch page to be entered. Any information can be entered in the fields shown i
9Wall Height Input Dialog Tapping on the toolbar will open the wall height input dialog (Image 16). From within this dialog, specify the
10This version of PlusDraw allows one area to be drawn per page, and the data shown on each of the View Tabs (tabs A, B, and C - Image 12) relates t
11 Once a connection is established, follow the steps outlined below: 1) Make sure the 2nd Function Layer is activated on the DISTO- Press
12 6) Continue drawing the Area in the same manner as described in steps 3-5 above. To properly calculate the area measurements, the area will n
13* Refer to the DISTO manual for more information on measuring and the 2nd Function Layer. Rise-and-Run Method Note: Rise-and-run measurement
14If the area has been completed and closed, the line may be edited by tapping the specific line with a stylus. The line will be highlighted in red
15 Tap the desired length using the number pad, and input the appropriate direction* using the directional arrow keys. Tap the
16 Saving and Exporting Files PlusDraw saves sketches by naming the sketch fi
Copyright © 2004 Randall H. Garrett, dba Apex IV, Limited. All Rights Reserved PlusDraw End-User License Agreement (EULA) Apex IV, Limited hereby
Table of Contents Preface... 1 About PlusDraw...
1Preface PlusDraw™ is distributed free-of-charge with the Leica DISTO™ plus laser distancemeter. This software was created by Apex Software in co
2Note: Older devices may require updated drivers (e.g. cummunication drivers) to function properly with the DISTO plus. Visit the PPC manufacturer&
3 Open the PlusDraw program (Start | Programs | PlusDraw). Depending on the PPC device and the drivers that are installed, one of thes
4For scenario 2, once PlusDraw has been launched, a new sketch file will open (Image 3). Begin drawing. For scenario 3, access the Bluetooth Mana
5Manual Setup First Time Communications Setup NOTE: Follow these instructions only if the PPC and the DISTO failed to connect as described in t
6 Tap OK. Once the COM port settings match, the previously described manual setup procedure will not be required. User Interface The term Use
Comments to this Manuals